Kasturi Sales

Minimum order quantity: 10 Piece

Fryolux Solder Paint Grade C
has three main advantages:-
1. Convenience and simplicity
2. Precision with economy
3. Suitability for mass production.
method of application-
fryolux solder paint is of suitable consistency for brush painting which is the normal and simplest method of application. If required its viscosity may be reduced by small addition of water or liquid frysol flux for dipping or spraying.
heating-
some of the heating methods in use for soldering with fryolux are-
gas touch - hotplate -0 internally heated iron -stoving - high frequency induction - electrical resistance - electro gas equipment - carbon electrode.
the tempreture required is similar to that of other soldering operations i. E. A superheat of some 30 - 50 c above the melting point of the solder . The melting point is 185c - 226c.
Fryolux Solder Paint GRADE C For Lead Lining & Copper Busbar

Minimum order quantity: 100 Piece

Frysol paste flux description frysol paste flux is a mid to dark brown, soft paste, designed for engineering and sheet metal work. The flux is active and contains zinc chloride and is suitable for soldering many metals including copper, brass and mild steel. Features and benefits  multi-purpose paste flux - effective soldering performance on a wide range of metals.  suitable for both lead containing and lead free solder alloys (fry powerflow wire and 99c lead free wire are particularly recommended). Application cleanliness is important for good results. Before soldering, all traces of oil, grease, dirt and rust should be removed from the area or parts to be soldered. Wire wool is the most commonly used method for this but emery paper is a good alternative cleaner. Soldering irons should be cleaned prior to use and before heating. A thin application of frysol is then applied so that the iron can be tinned with solder. Frysol is then applied to the area to be soldered, which can be heated with the iron or flame soldered. After soldering is complete, any excess flux residues must be removed with a damp cloth or by a water wash. This will minimise the risk of corrosion difficulties. When soldering copper piping, frysol need only be applied to the outside of the pipe surface where the joint is to be made. With the assembly of the copper pipe into the fitting, sufficient flux is transferred into the walls of the fitting and no excess flux is trapped inside the joint area. Heat is then applied to the joint area until a sufficient temperature is reached for soldering, which will complete the capillary action and secure the joint. Read instructions given in the container before using the product. Physical and chemical properties appearance: amber paste solubility: very slightly soluble in cold, hot water density: 1g/cm3 flash point: not applicable packaging frysol paste flux is available in 500g containers. Its shelf life is 6 months. Health and safety observe standard precautions for handling and use of corrosive liquids. Eye and skin protection must be provided. Avoid breathing fumes evolved during soldering. Adequate fume extraction should always be provided. For detailed information refer to the relevant health and safety data sheet (msds) available on request.